Free US shipping on orders over $144.98 to the lower 48 states*.

Solar When It's Sunny, Convective When It's Not: How Solar Blaster's Hybrid Vents Keep Air Moving 24/7

Sun mode vs convective mode diagram for a Solar Blaster hybrid vent

Most solar vents have one job: when the sun hits the panel, the fan spins. Solar Blaster vents are built to do two jobs. Dan Rheaume designed the fan platform with cutouts and holes so that air keeps moving even when the fan isn't.

Sun mode vs convective mode
Simplified drawing, not to scale. Arrows show direction only, not measured airflow.

Sun mode: the fan does the work

When sunlight hits the panel, the 120 mm fan pulls hot, moist air up out of the container and pushes it out under the hood. Fresh air comes in through the low intake vents to replace it.

Convective mode: the hot air does the work

At night, on cloudy days, or early in the morning, the fan slows or stops. Many vents just sit there. On ours, warm air inside the container still rises up through the cutouts and open gaps around the fan platform and out the hood.

It's the same physics we covered in What a Hot Air Balloon Teaches Us About Attic Ventilation. A hot air balloon rises because warm air is lighter than the cool air around it, and it breathes in from the bottom. Your container works the same way: cool air in low, hot air out high.

Looking up at an installed Conex Mega RoofBlaster from inside the container
Looking up from inside the container. The blue areas are the platform cutouts and gaps that let warm air rise past the fan when it's off.

We don't publish a CFM number for convective mode. It depends on how hot the inside is compared to outside, wind, and your intakes. What we can say is that the path is open, all day and all night.

Hybrid vs solar-only

Solar Blaster hybrid vents Solar-only vents (as their listings describe them)
Sunny Fan pulls air out Fan pulls air out
Night / clouds Warm air rises through the platform cutouts and out the hood Listings describe the fan running "when sunlight is present". No convective claim found.
Passive airflow when off Built into the vent itself Where mentioned, it comes from separate passive vents or a battery/AC adapter

We checked public listings for the container solar vents we see most (USA Containers, BigAir400, Conexwest, Krysolad) on November 15, 2026. We're not aware of any of them claiming convective flow through the fan unit when the fan is off.

Make the path clean: tape the stock vents

Convection only works if air has a clear path from low to high. Your container's small factory vents were made for its first life as a shipping container. In its new life it should breathe like a home: intake low like the eaves, exhaust high like the ridge. Put a piece of duct tape over each stock vent, and use four 2.5" intakes per solar vent, low on the shady side.

Sun or no sun, that's clothesline fresh air.

Ventilation helps reduce heat and moisture buildup, which lowers the risk of condensation, rust and mold. It isn't a cure for an existing mold problem. Solar Blaster fans are Assembled in America in Fountain Hills, AZ.

Multiple small Solar Blaster fans ventilate more uniformly and in a more balanced way than one large fan, with cool air in low and hot air out high.

The target for a shed or container is about 12 minutes per full air change. A 40-ft container gets two Mega vents with eight 2.5" intakes.

That indoor "rain" is the beer can effect: warm, moist air hits a cold metal surface and condenses, just like a cold beer can on a hot day.

Use code SHEDINTAKE on solar vents and LightBlasters only, never the passive VentBlaster. The free intake 4-pack applies to sheds and containers only (buy 2 shed vents, or any 2 Conex vents), not homes.

Powered by the Sun.